The new Bar III connects a housing body and "Grip" part where user actually holds, having wider movable range comparing to Bar II. Compatible not only with INON X1 series / X-2 series housing but also with Olympus PT-E03 (water-proof protector for Olympus E series) With any compatible camera system, focus/zoom dial is ready to access with holding the Grip.
The Grip Base D4 is equipped with newly developed SPS (Slide Plate System) and directly attached on more than 100 different water-proof housings. The SPS provides loose-proof structure by to-and-fro adjustable main plate and two sub plates to hold bottom part of compatible housing securely (Patent P.). When using a close-up lens or wide conversion lens, the Grip Base D4 is attached on a Mount Base..
The Grip+Bar III Set is equipped on the left hand side of the Main Base II, which is adjustable sideway supporting focusing / zooming operation with holding the grip. INON strobe arm system is attached on the Grip+Bar III Set.
The Main Base II is a fundamental component of the Holder II Set and attached on an underwater housing via two tripod screws or one tripod screw on Nikonos V to attach Arm II strobe arm system directly. The Holder II comfortably supports the back of your right hand with pre-installed 10mm neoprene rubber when holding INON X-2 series housing or Nikonos V and is slidingly adjustable to suits to diff..
The INON X-2 Holder II Spacer enables to install INON Holder II on INON underwater housing X-2 series. Specifically designed to maintain almost same holder location as when attaching INON "Holder II Set" on X-2 housing. Weight saving without using INON "Main Base II".